Phosphate buffered saline: Difference between revisions
No edit summary |
wikademia>Eme |
||
| (105 intermediate revisions by 66 users not shown) | |||
| Line 1: | Line 1: | ||
'''Phosphate buffered saline''' (abbreviated PBS) is a buffer solution commonly used in [[ | '''Phosphate buffered saline''' (abbreviated PBS) is a [[buffer solution]] commonly used in [[biology | biological research]]. It is a salty solution containing [[sodium chloride]], [[sodium phosphate]], and (in some formulations) [[potassium chloride]] and [[potassium phosphate]]. The buffer helps to maintain a constant [[pH]]. The osmolarity and ion concentrations of the solution usually match those of the human body ([[isotonic]]). | ||
{{ntnes}} | |||
==Applications== | |||
PBS has many uses because it is isotonic and non-toxic to cells. It can be used to dilute substances. It is used to rinse containers containing cells. PBS can be used as a diluent in methods to dry biomolecules, as water molecules within it will be structured around the substance (protein, for example) to be 'dried' and immobilized to a solid surface {{fact|date=April 2008}}. The thin film of water that binds to the substance prevents [[Denaturation_%28biochemistry%29 | denaturation]] or other conformational changes. Carbonate buffers may be used for the same purpose but with less effectiveness {{fact|date=April 2008}}. PBS can be used to take a reference spectrum when measuring the protein adsorption in ellipsometry {{fact|date=April 2008}}. | |||
Additives can be used to add function. For example, PBS with [[EDTA]] is also used to disengage attached and clumped cells. Divalent [[metals]] such as [[zinc]], however, cannot be added as this will result in precipitation. For these types of applications, [[Good's buffers]] are recommended. | |||
==Preparation== | |||
[[ | There are many different ways to prepare PBS. Some formulations do not contain potassium, while others contain calcium or magnesium<ref>Dulbecco, R. et al. (1954): ''Plaque formation and isolation of pure lines with poliomyelitis viruses''. In: ''J. Exp. Med.'' vol. 99 (2), pp. 167-182. PMID 13130792</ref>. One of the most common preparations is described below. | ||
The simplest way to prepare a PBS solution is to use PBS buffer tablets. They are formulated to give a ready to use PBS solution upon dissolution in a specified quantity of distilled water. They are available in the standard volumes: 100, 200, 500 and 1000 ml <ref>[http://www.medicago.se/_filer/PBS28-eng.pdf Medicago AB, (2003) Phosphate buffered saline pH 7.4 specification sheet]</ref>. | |||
A 10 liter stock of 10x PBS can be prepared by dissolving 800 g NaCl, 20 g KCl, 144 g Na<sub>2</sub>HPO<sub>4</sub> and 24 g KH<sub>2</sub>PO<sub>4</sub> in 8 L of distilled water, and topping up to 10 L. The pH is ~6.8, but when diluted to 1x PBS it should change to 7.4. When making buffer solutions, it is good practice to always measure the pH directly using a [[pH meter]]. If necessary, pH can be adjusted using [[hydrochloric acid]] or [[sodium hydroxide]]. | |||
On dilution, the resultant 1x PBS should have a final concentration of 137 mM NaCl, 2.7 mM KCl, 10 mM Sodium Phosphate dibasic, 2 mM Potassium Phosphate monobasic and a pH of 7.4. | |||
Another preparation is described in Molecular Cloning by Sambrook, Fritsch and Maniatis, Apendix B.12<ref>Sambrook, Fritsch, and Maniatis (1989) Molecular Cloning: A Laboratory Manual, 2nd ed., Cold Spring Harbor Laboratory Press, Cold Spring Harbor, New York, volume 3, appendix B.12</ref> as follows: | |||
For 1 litre of Phosphate-buffered saline (PBS buffer) use:.. | |||
*Dissolve in 800 ml of distilled H<sub>2</sub>O: | |||
*8 g of NaCl | |||
*0.2 g of KCl | |||
*1.44 g of Na<sub>2</sub>HPO<sub>4</sub> | |||
*0.24 g of KH<sub>2</sub>PO<sub>4</sub> | |||
*Adjust the pH to 7.4 with HCl or NaOH | |||
*Add H<sub>2</sub>O to 1 liter. | |||
Dispense the solution into aliquots and sterilize them by autoclaving (20 min, 121°C, liquid cycle). | |||
Store at room temperature. | |||
[[Category:Buffers]] | |||